components
21 | 21 |
| 20 |
23 |
REAR VIEW
22 |
FRONT VIEW
24 |
Figure 3. Major Components (Front/Rear)
13.Tongue Jackstand — Use this jackstand to support the tongue when attaching the light tower to a towing vehicle.
14.Safety Chain — Always attach safety chain to the towing vehicle. Never tow the light tower with the safety chain unattached.
15.Ball Hitch Coupler — Attach this coupler to the towing vehicle. Use only the specified ball diameter as indicated on your coupler. Use of any other ball diameter will create an extremely dangerous condition which can result in separation of the coupler and ball or ball failure.
16.Vertical Mast Winch — Use this winch to raise the mast to the vertical position.
17.Mast Lock/Release Pin — Pull this pin to start placing the tower mast in the vertical position. When tower mast has reached full vertical position, insert pin to keep mast from falling.
18.
19.Fuse Block Assembly — Contains the fuses that protect the lamp circuit breakers.
20.License Light — This light illuminates the license plate. Whenever towing of the light tower is required, make sure this light is operational.
21.Brake Lights — Before towing the light tower, make sure that these lights are operational and are working correctly. Never tow the light tower if these lights are inoperative.
22.Engine Exhaust Pipe — Directs engine exhaust to the rear of the light tower. NEVER block this exhaust pipe with obstructions. ALWAYS place the generator in an area free of obstructions.
23.Tires — This light tower uses ST205/75D15
24.Circuit Breakers, 3-Pole, 15 A — Turn the lamps on and off.
MLT25 SERIES LIGHT TOWER • operation manual — rev. #0 (11/28/12) — page 15
