Moxa Technologies Installing the Industio CP-134U Series Board, Hardware Installation

Hardware Installation

Installing the Industio CP-134U Series Board

Step 1: Power off the PC.

Warning! To avoid damaging your system and board, make sure your computer is turned off before installing any board.

Step 2: Remove the PC’s cover.

Step 3: Remove the slot cover bracket if there is one.

Step 4: Plug the Industio CP-134U Series control board firmly into a free 32-bit PCI slot, or the CP-134U Series board into both a 32-bit/64-bit slot.

Step 5: Fasten the holding screw to fix the control board in place.

Step 6: Replace the system cover.

Step 7: Power on the PC. The BIOS will automatically set the IRQ and I/O address.

Note! Each board must occupy one unique IRQ and two 8-byte I/O addresses, which are assigned automatically by the PCI BIOS. However, you can select a free IRQ number manually via the PC’s BIOS setup for the PCI slot, but normally this method is not available for the I/O address. The possible IRQ numbers are 2, 3, 4, 5, 7, 10, 11, 12, and 15. The possible I/O addresses are from 0x0000 to 0xFFFF.

Step 8: Proceed with the software installation discussed in the next chapter, “Software Installation.”

Industio CP-134U Series User’s Manual 2-7