N-Tron 102PC-SE Modem Configuration, Chatscript, Bridge Configuration, PPP Configuration

odtr

Dialout session is terminated when DTR signal on the serial port s0 toggles from High to Low

onone

Dialout session is not dependant on the DTR signal Default: none

Modem Configuration

∙Connect String: Sets the Modem Connect string

Default: CONNECT

∙OK String: Sets the Modem OK string

Default: OK

∙Hangup String: Sets the Modem hang-up string

Default: +++ATH0

∙Ring String: Sets the Modem Ring string

Default: RING

∙Dial Prefix: Sets the Modem Dial-Prefix

Default: ATDT

∙Dial Suffix: Sets the Modem Dial-suffix

Default: ^M

∙Dial Number: Sets the dial-number to be dialed Default: NULL

∙Dialing method: Sets the modem dialing method Description

o Configuration method: User shall provide only the dial-number to reach

o Chat-script method: User can write his/her own script by providing an "Expect" and a "Send" sequence Refer to: chat-script for providing an "Expect" and a "Send" sequence

Default: configuration

∙Init String: Configure the Modem init strings Init-num can range from 1-5

Chatscript

∙Sets/Clears expect and send strings for the chat script to act on the modem

Bridge Configuration

∙Bridge: Enables/disables remote transparent bridging between ethernet and serial interface. Enabling bridge will automatically enable telnet, tftp services on the module. Disabling will automatically disable PPP on the module

Default: disable

∙IP Address: Sets Bridge IP address. Can be set only when Bridge is enabled

Default: Ethernet ip address

∙IP Mask: IP mask of the configured IP address

PPPConfiguration

∙PPP :Enableis/Disables PPP on the serial port s0. PPP can be enabled only if bridge is enabled

Default: disable

∙Compression:Enables/Disables CCP compression for PPP

Default: disable

∙Compression Type: Sets the compression type to bsd, deflate or both

oPPP in non raw-mode:

When "both" is configured as the compression type, the module tries to negotiate deflate first. In the event of failure, the bsd is negotiated

oPPP in raw-mode:

Compression type "both" is not supported in raw-mode, since there is no negotiations between SocketEthernet IP Modules Default: deflate

∙Raw Mode: Enables/Disables simple AHDLC framing on the Serial side. In Raw mode, no PPP negotiations are done on the serial. The ethernet data is encapsulated with 7E delimiters. FCS is part of the AHDLC frame header

Default: disable

∙Authentication: Enables/Disables PPP authentication

Default: disable

∙Authentication Type: Sets the authentication protocol type to negotiate with the remote peer: pap/chap/pap-chap

Default: pap

∙Username: PPP username with which remote peer will authenticate

Default: ipmodule

∙Password: PPP password with which remote peer will authenticate

Default: ipmodule

(continued…)

IPGeneral

∙Hostname: Sets the hostname for the module

Default: SocketEthernetIP

12/1/2006 21