Scenario 3 – Auto Dialout Using UDP
In this scenario, the Auto Dial-out session in UDP mode is initiated by an external UDP Client.
Auto Dialout Feature using UDP Mode
Commands to Setup UDP Dial-out in the 102PC-SE
#set ip eth0 dhcp-client disable
#set ip eth0 ip-address 192.168.2.1
#set ip auto-dialout enable
#set serial s0 auto-dialout enable
#set serial s0 auto-dialout-port 5000
#set serial s0 auto-dialout-protocol udp/all
#set serial s0 baud-rate 115200
#set serial s0 data-bits 8
#set serial s0 parity none
#set serial s0 stop-bits 1
#set serial s0 flow-control rts-cts
#set serial s0 dialout-monitor dtr
#set ip udp inactivity enable/disable
#set ip udp inactivity-timeout t
#set ip udp terminate-monitor enable/disable
#set ip udp terminate-string <string>
#save
Functionality
When any UDP client connects to the 102PC-SE on the configured port, the 102PC-SE locks the serial port for that UDP-Client and latches to the UDP client address connected. The UDP-Client is now ready to send or receive data to or from the serial device.
How to Terminate the UDP-Dialout Session
1.If the “ inactivity” is enabled and the timeout value is configured, t he active UDP session will be terminated on the expiry of inactive timeout.
2.If the “ terminate-monitor”is enabled, the UDP-Client can terminate the session by sending the terminate-string configured in the 102PC-SE.
3.If both “ inactivity” and “ terminate-monitor” are enabled, the UDP dialout session is terminate d on any of the above two events that occurs first.
4.When the “ dialout-monitor”is set to dtr, toggling the DTR signal state terminates The UDP-dialout session.
Notes
•Authentication is NOT supported for the UDP Dialout feature.
•At any given point of time, only one “UDP Client” c an send or receive data from the serial-device through the 102PC-SE.
•# set serial s0 raw-mode <enable/disable> is NOT applicable for the UDP Auto-dialout feature.
