Scenario 4 – Remote Bridging with Modem Connection
This example of remote transparent bridging uses a modem connection between the serial ports.
Transparent Bridging with Modem Connection
Commands Setup for | Commands Setup for |
# set ip eth0 |
|
# set ip eth0 ip 192.168.2.1 | # set ip eth0 |
# set bridge enable | # set ip eth0 ip 192.168.2.10 |
# set bridge ipmodule | # set bridge enable |
# set ppp ppp0 enable | # set bridge ipmodule |
# set ppp ppp0 | # set ppp ppp0 enable |
[Only if simple AHDLC quoting on the serial port is required.] | # set ppp ppp0 |
# set serial s0 | [Only if simple AHDLC quoting on the serial port is required.] |
# set serial s0 | # set serial s0 |
# set serial s0 modem | # set serial s0 |
# set serial s0 modem | # set serial s0 modem |
# set serial s0 modem | # set serial s0 modem |
# set serial s0 | # set serial s0 |
# set serial s0 | # set serial s0 |
# set serial s0 parity none | # set serial s0 parity none |
# set serial s0 | # set serial s0 |
#save
Notes:
1.For simple AHDLC quoting on the serial port, the
2.
3.If you wish to have a complete control on the
4.Refer the following commands in the Command Line Section for more details on the chatscripts.
#set serial s0 modem
#set serial s0
Important Note:
The
12/1/2006 | 30 |
