20
GRATE INSTALLATION
The grate for this fireplace has been removed for shipping purposes.
The grate must be installed before the logs are installed.
Remove the packaging from the grate and install onto the two pins as illustrated.
LOG PLACEMENT
PHAZERTM logs and glowing embers, exclusive to Napo- leon Fireplaces, provide a unique and realistic glowing ef- fect that is different in every installation. Take the time to carefully position the glowing embers for a maximum glow- ing effect. Log colours may vary. During the initial use of the fireplace, the colours will become more uniform as colour pigments burn in during the heat activated curing process.
FIGURES40a-d
3.Tear the glowing embers into pieces and place along the front row of ports covering all of the burner area in front of the small logs (#2 & #3). Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame; however, care should be taken to not block the burner ports. Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct flame.
#1 |
|
|
1. Place the cutout in the bottom of log #1 behind the pilot | #4 | #5 |
|
|
assembly. Rest the log against the back wall of the firebox.
#2 #3
2.Move the two small logs (#2 & #3) into position, lining up the studs located on the burner with the holes on the bottom of the logs.
GLOWING EMBERS
4.Cradle the notch on the bottom of the left crossover log (#4) around the left side of the grate and the top into the pocket provided on the back log. Place the end of the center log (#5) against the grate, as shown, with the other end of the log resting in the pocket of the left crossover log.
#6
5.Place the bottom of the right crossover log (#6) against the right side of the grate. Place the top into the pocket provided on the center log (#5).
