ANDIRON PLACEMENT
Andirons are pack- aged seperately in- side the unit and must be installed prior to the log installation. Place the Andiron on the Andiron brackets located at the front of the unit lining up the holes. Secure using the screws provid- ed. Repeat on other side.
LOG PLACEMENT
PHAZER™ logs and glowing embers, exclusive to NA- POLEON® Fireplaces, provide a unique and realistic glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect. Log colours may vary. During the initial use of the fireplace, the colours will become more uniform as colour pigments burn in during the heat activated curing process.
1
1.Center the rear log (#1) behind the rear burner and onto the log support.
17
5
4.Place the small branch of log#5 into the notch on log#3. The notches on the bottom edge of log #5 should sit on the first and second grate posts from the left.
6
5.Place the small end of log#6 into the front notch of log#4. Place the locating hole in the large end of log#6 onto the locating pin on top of log#2.
7
6.Place the pin in log #7 in the hole in log #6. The log should sit in the notch on log #2 and the bottom should rest along the right side of the Andiron.
8
32
2.Place log#2 and log#3 onto the locating pins. The logs should sit flat on the burner.
4
3.Place the locating hole on the underside of log#4 onto the locating pin on top of log#3. The notch at the oppo- site end of log#4 sits on the third grate post in from the right side.
7.Place the large end of log#8 into the rear notch of log#4.
The small branch of log#8 sits in the notch located on top of log#1.
10
9
8.Place log#9 onto the grate as though it had burnt off log#5. Place log#10 onto the locating pin on log#1. Again, log#10 should be aligned as though it has burnt off of log#7.
