Napoleon Fireplaces Fireplace Finishing, Clearances To Combustibles, Door Removal, Glass Removal

15

CLEARANCES TO COMBUSTIBLES

Minimum clearance to combustible construction from fireplace and vent surfaces:

Fireplace framing: -	6” to top
-	0” to stand-offs	COMBUSTIBLE	NON-COMBUSTIBLE

Vent pipe: Recessed depth:

	(rear and sides)
-	1”	BRICK
-	7”
	12”
	MIN. TO	6”
	COMBUSTIBLES	MIN.
	(to ceiling or mantle)
		1”	FRAME
			0” IF
			NON-COMBUSTIBLE
			FINISHING IS USED
			SUCH AS BRICK AN
			STONE.
		1”
	* Any protruding finishing	1 1/2” MIN.
	material installed in this
	space (ie. baseboards)
	must leave 2” of		CONTROL DOOR
	unobstructed clearance to		(OPEN POSITION)
	allow for full rotation of the
	control door.
	2” MIN.*	FIGURE 23

WITHOUT FRAME INSTALLED WITH FRAME INSTALLED

FINISHING

DOOR REMOVAL

Before the glass door can be removed, the optional frame/	CLOSED		OPEN
front must be removed.		FIGURE 24
The glass door is secured to the top front edge of the firebox.
Pull the handles of the latches forward, then lift the hooks out
from the slots in the door frame to release the top of the door.
Then, pivot forward until the top edge of the door clears the
front of the fireplace. Next gripping the sides of the door lift
the door out from the retainer along the bottom of the door.

GLASS REMOVAL

Having removed the door, lay on a smooth flat surface, face down. There are 4 glass retainers that need to be bent away

from the glass to release it from the frame. Do not pry onGLASS the glass.

When replacing DO NOT SUBSTITUTE MATERIAL, replace the gasket (W562-0008) and the glass (W300-0088). Set new glass into the frame and gently bend tabs into the gasket to secure.

NOTE: Care must be taken when removing and disposing of any broken glass or damaged components. Be sure to vacuum up any broken glass from inside the fireplace before

operation. FIGURE 25

GASKET

GLASS

RETAINERS

W415-0619 / B / 03.03.08