ACCENT GLASS INSTALLATION
Carefully sprinkle the accent glass onto the glass support evenly. Ensure no glass falls into the burner area. If this happens, insert a clean bag into your vacuum cleaner and BURNER vacuum out the accent glass. Replacement accent glass
can be purchased from Wolf Steel Ltd.
FIGURE 30
17
ACCENT
GLASS
GLASS 
SUPPORT
LK8 LIGHT INSTALLATION (OPTIONAL)
1. Turn off the electrical and gas supply to the fireplace. |
|
|
|
|
| |
2. Remove the frame from the unit by removing the 2 black securing |
|
|
|
|
| |
screws from the top, and the 2 silver hex head securing screws from |
|
|
|
|
| |
the bottom. |
|
|
|
|
| |
3. Lay the frame down on its front, being careful not to scratch the |
|
|
|
|
| |
finish. |
|
|
|
|
| |
4. Starting at the top of the frame, take one light assembly and carefully |
|
|
|
|
| |
snap it into place in the hole provided. Repeat for each of the light |
|
|
|
|
| |
assemblies. The wires on the top 2 light assemblies will need to be fed |
|
|
|
|
| |
in behind the heat shields. |
|
|
|
|
| |
Note: When installing the light kit be careful not to scratch your |
|
|
|
|
| |
| fingers on any of the exposed screws in the frame. |
|
|
|
|
| |
5. Using Figure 31 as a guide, connect the light assemblies to the |
|
|
|
|
| |
|
| TL | ||||
appropriate flags on the wire harness. The wire harness is labeled (TR) |
|
| ||||
top right, (BR) bottom right (TL) Top left and (BL) bottom left. |
|
|
|
|
| |
|
|
|
|
| ||
6. Secure the wires into the clips at both sides and the bottom of the |
|
|
|
|
|
|
|
|
|
|
|
| |
frame. Use the extra clips provided to retain any loose wires. |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| |
7. |
|
|
|
|
| |
8. Remove the control panel by removing the 2 screws securing it along |
|
|
|
|
| |
the top edge. Leave the wires connected to the ON/OFF switch. |
|
|
|
|
| |
| BL |
| ||||
9. Place the transformer into the bottom of the unit. Plug the transformer |
|
| ||||
into the receptacle. |
|
|
|
|
| |
10. Lay the control panel flat along the bottom edge of the frame. Attach |
|
|
|
|
| |
one of the wire leads from the transformer to the lead on the wire harness |
|
|
|
|
| |
labeled “TRANS”, and the other to the ON/OFF switch. Attach the last |
|
|
|
|
| |
|
|
|
|
| ||
lead on the wire harness labeled “SWI” to the ON/OFF switch. |
|
|
|
|
| |
11. |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| |
12. Turn on the gas supply and electrical power. |
|
|
|
|
| |
CLIPS X5
TR
BR
FIGURE 31
SW I
