15
FINISHING
LOGO PLACEMENT
Remove the backing of the logo supplied and centre over the logo installation holes, as indicated.
FIGURE 37
TOP | FIGURE 38b |
| FIGURE 38c |
HANDLE
LOGO
RETAINER
FRONT CAST INSTALLATION
FRONT
'T' LATCH
1.Lift the top casting off the unit.
2.Fit the securing bolts on the cast front into each of the respective retainer brackets (located at either side on the top SEE FIGURE 37b). Insert and tighten the securing screw from the bottom up (located at the lower center behind the cast front SEE FIGURE 37a). This will hold the cast front in place. Replace the top casting.
3.To remove the front, repeat in reverse order.
GLASS DOOR INSTALLATION
AND REMOVAL
RIDGE
RETURN FLANGE
FIGURE 38d
When installing the glass door, a simple procedure must be followed in order to not damage the door.
1.Lift the top casting off.
2.Undo the securing screw (located at the lower center of the cast front) holding the cast front in place. Figure 37a.
3.Lift the cast front out of its retainers (located at either side on the top). Figure 37b.
4.Open the valve control cover. Pull the latch handles forward to release. Figure 37c. The door may now be safely removed by swinging the bottom out and lifting it off. To install the door, repeat in reverse order.
The return flange must fit over the top of the ridge so that it rests on top of the firebox. Figure 37d . The 'T' latch portion is threaded and can be loos- ened or tightened to adjust for an effective door seal. Care must be taken when