Napoleon Fireplaces GS60-N, GS60-P manual Trouble Shooting Guide, Symptom, Problem, Test Solution

22

TROUBLE SHOOTING GUIDE

BEFORE ATTEMPTING TO TROUBLESHOOT, PURGE YOUR UNIT AND INITIALLY LIGHT THE PILOT AND THE MAIN BURNER WITH THE GLASS DOOR REMOVED.

	SYMPTOM						PROBLEM		TEST SOLUTION
Pilot will not light.						No spark at pilot burner		-	check if pilot can be lit by a match
								-	check that the wire is connected to the push button ignitor.
								-	check if the push button ignitor needs tightening.
								-	replace the wire if the wire insulation is broken or frayed.
								- replace the electrode if the ceramic insulator is cracked or
								broken.
						Spark gap is incorrect		- spark gap should be 0.150" to 0.175" (5/32" to 11/64" approx.)
								from the electrode tip and the pilot burner. To ensure proper
								electrode location, tighten securing nut (finger tight plus 1/4
								turn).
					No gas at the pilot burner			-	check that the manual valve is turned on.
								-	check the pilot orifice for blockage.
								-	replace the valve.
								-	call the gas distributor.
						Out of propane gas.		-	fill the tank.
Pilot goes out when					System is not correctly purged.			-	purge the gas line with the stove door open.
the gas knob is re-					Out of propane gas			-	fill the tank.
leased.
					Pilot flame is not large enough			-	turn up the pilot flame.
						Pilot flame is not engulfing the		-	turn up pilot flame.
						thermocouple.		-	replace pilot assembly.
					Thermocouple shorting.			-	loosen and tighten thermocouple.
								-	clean thermocouple and valve connection.
								-	replace thermocouple.
								-	replace valve.
					Faultly thermocouple.			-	replace.
					Faulty valve.			-	replace.
	Pilot	burning;		no	Main burner orifice is plugged.			-	remove stoppage in orifice.
	gas	to	main
						Faulty thermopile.		-	replace.
	burner; gas knob
						Faulty themostat or switch.		-	connect a jumper wire across the wall switch terminals; if
	is on 'HI';			wall
								main burner lights, replace thermostat.
	switch / thermostat
								-	disconnect switch wires from the valve & connect a jumper
	is on.
								wire across terminals 1 & 3; if the main burner lights, check the
								wires for defects and / or replace wires.
						Faulty valve.		-	replace.
Pilot goes out while						Gas piping is undersized.		-	turn on all gas appliances and see if pilot flame flutters,
standing;			Main					diminishes or extinguishes, especially when main burner ig-
burner is in 'OFF'								nites. Monitor supply pressure.
position.								-	check if supply piping size is to code. Correct all undersized
								piping.
Main		burner	goes		Pilot flame is not large enough			-	turn up pilot flame.
out; pilot stays on.					or not engulfing the thermo-			- replace pilot assembly.
					pile.
					Thermopile shorting			-	clean thermopile and thermopile connection to valve.
					Remote wall switch wire is too			- shorten wire to correct length or wire gauge.
					long, too much resistance in
					the system
					Faulty thermostat or switch			- replace
					MODEL GS60 ONLY:			- test with spill switch bypassed. Replace if defective.
					Venting is spilling			- check for vent blockage.

W415-0158 / E / 02.19.04