5

Natural Gas Hook-Up: These connections must be made by a licensed gas fitter. This natural gas grill is sup- plied with a gas supply hose (complete with a quick disconnect) designed for natural gas and certified for outdoor use. The gas grill is designed to operate at an inlet pressure of 7 inches water column. Piping and valves upstream of the quick disconnect are not supplied. The installation must comply with CAN B149.1 Natural Gas and Propane installation code in Canada, or to the National Fuel Gas Code, ANSI Z223.1 in the United States. The gas supply pipe must be sufficiently sized to supply the BTU/h specified on the rating plate, based on the length of the piping run.

The quick disconnect must not be installed in an upward direction and a readily accessible manual shut-off valve must be installed upstream of, and as close to, the quick disconnect as is feasible. The flared end of the hose must be connected to the fitting on the end of the manifold tube or flex tube (if applicable) as illustrated in the Natural Gas Hose Attachment diagram. Tighten using two wrenches. (Do not use thread sealer/pipe dope.) Leak test all joints prior to using the gas grill.

WARNING!

The installation must be performed by a licensed gas fitter, and all connections must be leak tested before operating the grill.

Do not route hose underneath the drip pan.

Do not route hose between bottom shelf space and back panel.

Do not route hose over top of rear panel.

Ensure all hose connections are tightened using two wrenches. Do not use Teflon tape or pipe dope on any hose connection.

Ensure the hose does not contact any high temperature surfaces or it may melt and leak causing a fire.

Leak test all the connections using a soap and water solution as per the leak testing instructions found in the manual.

The outdoor cooking gas appliance and its individual shutoff valve must be disconnected from the gas sup- ply piping system during any pressure testing of that system at test pressures in excess of 0.5 psi (3.5 kPa).

The outdoor cooking gas appliance must be isolated from the gas supply piping system by closing its indi- vidual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa).

Leak Testing Instructions

WARNING! A leak test must be performed annually and each time a cylinder is hooked up or if a part of the gas system is replaced.

Warning! Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage to property, serious bodily injury, or death.

Leak testing: This must be done before initial use, annually, and whenever any gas components are replaced or serviced. Do not smoke while performing this test, and remove all sources of ignition. See Leak Testing Diagram for areas to check. Turn all burner controls to the off position. Turn gas supply valve on.

Brush a half-and-half solution of liquid soap and water onto all joints and connections of the regulator, hose, manifolds and valves.

Bubbles will indicate a gas leak. Either tighten the loose joint or have the part replaced with one recommend- ed by the Napoleon Customer Care department and have the grill inspected by a certified gas installer.

If the leak cannot be stopped, immediately shut off the gas supply, disconnect it, and have the grill inspected by a certified gas installer or dealer. Do not use the grill until the leak has been corrected.

www.napoleongrills.com

Page 5
Image 5
Napoleon Grills PRESTIGE II 600 manual Leak Testing Instructions

PRESTIGE II 600 specifications

The Napoleon Grills PRESTIGE II 600 is a leading-edge gas grill that embodies high performance, stylish design, and remarkable cooking versatility. An ideal choice for outdoor cooking enthusiasts, this grill features a host of characteristics that enhance both the grilling experience and the quality of the food prepared.

One of the standout features of the PRESTIGE II 600 is its impressive cooking space. With a total of 720 square inches of cooking area, this grill allows ample room to prepare meals for gatherings, family barbecues, or entertaining friends. The grill is equipped with four main burners that deliver a total of 48,000 BTUs of heat, ensuring that food cooks evenly and efficiently.

The innovative infrared side and rear burners are notable technologies that set this grill apart. The ceramic infrared side burner is perfect for searing steaks, delivering high and consistent heat to lock in juices and flavor. The rear infrared burner transforms the grill into a functional rotisserie, allowing for perfectly cooked meats that are tender and flavorful. The rotisserie kit, often included with the grill, helps create meals that wow your diners.

The Napoleon PRESTIGE II 600 is constructed with high-quality, stainless steel materials that ensure durability and longevity. The elegant finish not only provides a modern aesthetic but also resists rust and corrosion, so your grill looks good even after years of use. The grills feature a unique design with the Wave cooking grids that facilitate even heat distribution while also creating attractive grill marks.

Additionally, the grill is equipped with advanced technology, including the Accu-Probe temperature gauge that allows for precise cooking control. This feature ensures you can achieve the exact doneness desired for your meats. Moreover, the integrated lighting system in the grill provides excellent visibility, enhancing your cooking experience even during nighttime grilling sessions.

Another characteristic of the PRESTIGE II 600 is its convenient storage solutions. The grill features enclosed cabinet space for storing propane tanks and grilling accessories, keeping everything organized and within reach.

The Napoleon Grills PRESTIGE II 600 is more than just a grilling appliance; it’s a versatile outdoor cooking tool that combines functionality with curated design, making it a premier choice for any outdoor cooking enthusiast.