Chapter1 Installingand Configuring the SCXI-119X
SCXI-1190/1191/1192User Manual 1-6 ni.com
Note Wheninstalling the SCXI-119 XmoduleinanSCXIchassis,fillslot1first,thenfill
slot 2 with the nextSC XI-119X.
5. Insert anyother S CXI modules into the remaining slots in the same
manneras described in step 4.
6. Secure all the SCXI-119Xmodules to the SCXI chassis by tightening
both module thumbscrews.
Connecting the SCXI-119Xto a DAQ Device or Computer-BasedInstrument
You need the following items:
•SCXIchassis with the SCXI modules i nstalled (Refer to the Installing
the SCXI-119X Module into an SCXI Chassis section for more
information.)
•SCXI cable assembly,which consists of a cable adapter and a cable
•An installed National Instruments DAQdevice or computer-based
instrument, such as the NI 4060, that is able to control the SCXI
chassis
•1/4 in. flathead screwdriver
Consult your SCXI chassis documentation, other SCXI module
documentation,and DAQ device or computer-based instrument
documentation for additional instructions and warnings. YourSCXI-119X
module and anyoth erSCX I modules should already be installed in the
chassisaccording to their installation instructions.
Youmust select one of the modules in the chassis as the cabled
module—the module to which the SCXI cable assembly connects. If the
chassiscontains at least one SCXI-1140 module, select an SCXI-1140 as
the cabled module; otherwise, select one of the remaining modules.
Note The SCXI-119Xmodules operate only in multiplexed mode.