Chapter 7 Counters
NI 6124/6154 User Manual 7-32 ni.com
Other Counter FeaturesCascading Counters
You can internally route the Counter n Internal Output and Counter n TC
signals of each counter to the Gate inputs of the other counter. By cascading
two counters together, you can effectively create a 64-bit counter. By
cascading counters, you also can enable other applications. For example, to
improve the accuracy of frequency measurements, use reciprocal
frequency measurement, as described in the Method 3 bullet in the
Frequency Measurement section.
Counter Filters
You can enable a programmable debouncing filter on each PFI, RTSI, or
PXI_STAR signal. When the filters are enabled, your device samples the
input on each rising edge of a filter clock. S Series devices use an onboard
oscillator to generate the filter clock with a 40 MHz frequency.
Note NI-DAQmx only supports filters on counter inputs.
The following is an example of low to high transitions of the input signal.
High to low transitions work similarly.
Assume that an input terminal has been low for a long time. The input
terminal then changes from low to high, but glitches several times. When
the filter clock has sampled the signal high on N consecutive edges, the low
to high transition is propagated to the rest of the circuit. The value of N
depends on the filter setting; refer to Table7-4.
Table 7-4. Filters
Filter Setting
N (Filter Clocks
Needed to
PassSignal)
Pulse Width
Guaranteed to
Pass Filter
Pulse Width
Guaranteed to
Not Pass Filter
125 ns 5125 ns 100 ns
6.425 μs 257 6.425 μs6.400 μs
2.56 ms ~101,800 2.56 ms 2.54 ms
Disabled ———