National Instruments 370551A-01, NI-VISA, NI-VXI - page 115

Appendix C EEPROM Configuration
© National Instruments Corporation C-3 PCI-MXI-2 for Linux
Note If you have to remove the PCI-MXI-2 module to access switch 1, follow the
installation instructions given in Chapter 2, PCI-MXI-2 Configuration andInstallation,
tor einstall the PCI-MXI-2 module.
4. Replace the computer cover.
5. Turn on the computer. The computer should boot this time because the
factory-default configuration is being used to initialize the PCI-MXI-2
module.
6. Run vxiedit to readjust the PCI-MXI-2 configuration. Refer to
Chapter 6, NI-VXI Configuration Utility, for instructions on using this
utility.
7. After saving the configuration, reboot the computer.
8. Remove the top cover or access port to the PCI bus.
9. Change switch 1 (FOV) on U17 to the OFF position.
10. Replace the computer cover.
11. Turn on the computer. If the computer does not boot with this
configuration, you will have to repeat these steps, modifying your
configuration until a final configuration is reached.