© National Instruments Corporation 3-1 PCI-MXI-2 for Linux
3
VXI-MXI-2 Configuration and Installation
This chapter contains the instructions to configure and install the
VXI-MXI-2 module. This chapter applies only if you ordered the VXI
MXI-2 kit. If you ordered the VME MXI-2 kit, skipthis chapter and refer
to Chapter 4, VME-MXI-2 Configuration andInstallation.
Caution Electrostatic discharge can damage several components on your VXI-MXI-2
module. To avoid such damage in handling the module, touch the antistatic plastic package
to a metal part of your VXI chassis before removing the VXI-MXI-2 from the package.
Configure the VXI-MXI-2
This section describes how to configure the following options on the
VXI-MXI-2:
• VXIbus logical address
• VXIbus Slot 0/Non-Slot 0
• VXIbus local bus
• VXIbus CLK10 routing
• Trigger input termination
• MXIbus termination
• Configuration EEPROM
• Onboard DRAM
Note If you have only one VXI chassis in your system, you shou ld leave the VXI-MXI-2
at Logical Address 1 and install it into Slot 0. To install the VXI-MXI-2, refer to the Install
the VXI-MXI-2 section.
Figure3-1 shows the VXI-MXI-2 as it would appear when facing the right
side cover. The drawing shows the location and factory-default settings of
most of the configuration switches and jumpers on the module. Notice that
switch S6 is accessible only by removing the front cover.