Chapter 4 | Analog Input |
Using an Internal Source
One of the following internal signals can drive ai/SampleClock.
•Counter n Internal Output
•AI Sample Clock Timebase (divided down)
•A software pulse
A programmable internal counter divides down the sample clock timebase.
Using an External Source
Use the external signals PFI <0..3> or PFI <8..11> as the source of ai/SampleClock.
Routing AI Sample Clock Signal to an Output Terminal
You can route ai/SampleClock out to any PFI <4..7> or PFI <12..15> terminal. This pulse is always active high.
You can specify the output to have one of two behaviors. With the pulse behavior, your DAQ device briefly pulses the PFI terminal once for every occurrence of ai/SampleClock.
With level behavior, your DAQ device drives the PFI terminal high during the entire sample.
Other Timing Requirements
Your DAQ device only acquires data during an acquisition. The device ignores ai/SampleClock when a measurement acquisition is not in progress. During a measurement acquisition, you can cause your DAQ device to ignore ai/SampleClock using the ai/PauseTrigger signal.
A counter on your device internally generates ai/SampleClock unless you select some external source. ai/StartTrigger starts this counter and either software or hardware can stop it once a finite acquisition completes. When using an internally generated ai/SampleClock, you also can specify a configurable delay from ai/StartTrigger to the first ai/SampleClock pulse. By default, this delay is set to two ticks of the ai/SampleClockTimebase signal. When using an externally generated ai/SampleClock, you must ensure the clock signal is consistent with respect to the timing requirements of ai/ConvertClock. Failure to do so may result in ai/SampleClock pulses that are masked off and acquisitions with erratic sampling intervals. Refer
© National Instruments Corporation |