© National Instruments Corporation 23 NI WLS/ENET-9163 Carrier User Guide and Specifications
Specifications
These specifications are typical at 25°C unless otherwise noted.
For CSeries I/O module specifications, refer to the documentation
included with the modules.
Note These specifications are for the NI WLS/ENET-9163 carrier only, unless otherwise
noted.

Analog Input

Input FIFO size...................................... 4095 samples >16 bit
8191 samples ≤16 bit
Sample rate1
NI WLS/ENET-9163 carrier...........5 MS/s (multi-channel,
aggregate), maximum
With NI WLS/ENET-9215............. 100 kS/s, maximum
Timing accuracy2...................................50 ppm of sample rate
Timing resolution2.................................50 ns
Number of channels supported.............. Determined by the C Series
I/O module

Digital Triggers

Static Characteristics

Number of terminals.............................. 2 bi-directional, individually
settable
Pull-down resistor.................................. 49.9 kΩ ±0.5%
Input voltage protection3........................±20 V on each pin
Power–on state.......................................Input
Required minimum input pulse width.... 100 ns
1 Performance dependent on type of installed C Series I/O modules and number of channels in the task.
2 Does not include group delay. Refer to C Series I/O module documentation for more information.
3 Stresses beyond those listed under Input voltage protection may cause permanent damage to the device.