NI WLS/ENET-9163 Carrier User Guide and Specifications 30 ni.com
Electromagnetic Compatibility
This product is designed to meet the requirements of the following
standards of EMC for electrical equipment for measurement, control,
and laboratory use:
• EN 61326 EMC requirements; Minimum Immunity
• EN 55011 Emissions; Group 1, Class A
• CE, C-Tick, ICES, and FCC Part 15 Emissions; Class A
• EN 301489-011, EN 301489-171
•FCC 15-247
1, IC RSS-2101, EN 3003281
Note For EMC compliance, operate this device according to product documentation. For
country-specific restrictions, go to ni.com/certification, search by model number or
product line, and click the appropriate link in the Certification column
Electronic Compatibility Information
This hardware has been tested and found to comply with the applicable
regulatory requirements and limits for electromagnetic compatibility
(EMC) as indicated in the hardware’s Declaration of Conformity (DoC).
These requirements and limits are designed to provide reasonable
protection against harmful interference when the hardware is operated in
the indicated electromagnetic environment. In special cases, for example
when either highly sensitive or noisy hardware is being used in close
proximity, additional mitigation measures may have to be employed to
minimize the potential for electromagnetic interference.
While this hardware is compliant with the applicable regulatory EMC
requirements, there is no guarantee that interference will not occur in a
particular installation. To minimize the potential for the hardware to cause
interference to radio and television reception or to experience unacceptable
performance degradation, install and use this hardware in strict accordance
with the instructions in the hardware documentation and the DoC.
If this hardware does cause interference with licensed radio
communications services or other nearby electronic hardware, which can
be determined by turning the hardware off and on, you are encouraged to
try to correct the interference by one or more of the following measures:
• Reorient the antenna of the receiver (the device suffering interference).
• Relocate the transmitter (the device generating interference) with
respect to the receiver.
1 NI WLS-9163 carrier only.