©NationalInstruments Corporation A-1 PXI-846xand NI-CAN for Windows NT
A

Uninstalling the Hardware

and Software

This appendix describes howto uninstall the PXI-84 61 or PXI-8460
hardwareand the NI-CAN software from Windows NT.

Uninstalling the Hardware from Windows NT

BecauseWindows NT 3.51 and 4.0 do not maintain hardware information
forthe board, you just need to p hysically removeyour PXI hardware from
your computer.To do so, shut down Windows NT,power off your PXI or
CompactPCIchassis, remove any cables attached to your board, and
physically removethe board.

Uninstalling the NI-CAN Software from Windows NT

Note Thefollowing instructions apply to Windows NT 4.0 only. If you are using Windows
NT3.51, refer t o the readme.txt filein your NI-CAN directory for information on how
to uninstall the NI-CAN software.
Before uninstalling the NI-CAN software, you should removeall
PXI-8460, PXI-8461, or PXI-8462 boards from your computer, as
explainedin the previous section.