© National Instruments Corporation E-1 SCXI-1121 User Manual
E

SCXI-1121 Cabling

This appendix describes how to use and install the hardware accessories for
the SCXI-1121:
• SCXI-1340 cable assembly
• SCXI-1341 Lab-NB, Lab-PC, and Lab-PC+ cable assembly
• SCXI-1344 Lab-LC cable assembly
• SCXI-1342 PC-LPM-16 cable assembly
• SCXI-1180 feedthrough panel
• SCXI-1302 50-pin terminal block
• SCXI-1351 one-slot cable extender
• SCXI-1350 multichassis adapter
• SCXI-1343 screw terminal adapter

SCXI-1340 Cable Assembly

The SCXI-1340 cable assembly connects an MIO-16 board to an
SCXI-1121 module. The SCXI-1340 consists of a 50-conductor ribbon
cable that has mounting bracket at one end and a 50-pin female connector
at the other end. The female connector connects to the I/O connector of the
MIO-16 board. Attached to the mounting bracket is a 50-pin female
mounting-bracket connector that connects to the module rear signal
connector. To extend the signals of the MIO-16 board to an SCXI-1180
feedthrough panel or an SCXI-1181 breadboard module, you can use the
male breakout connector that is near the mounting bracket on the ribbon
cable. All 50 pins from the MIO-16 board go straight through to the rear
signal connector.