Appendix E SCXI-1121 Cabling
SCXI-1121 User Manual E-4 www.natinst.com
Figure E-1. SCXI-1340 Installation
SCXI-1341 Lab-NB, Lab-PC, or Lab-PC+ and SCXI-1344 Lab-LC Cable Assembly
The SCXI-1341 Lab-NB, Lab-PC, or Lab-PC+ cable assembly connects a
Lab-NB, Lab-PC, or Lab-PC+ board to an SCXI-1121 module. The
SCXI-1344 Lab-LC cable assembly connects a Lab-LC board to an
SCXI-1121 module. The SCXI-1341 and SCXI-1344 cable assemblies
consist of two pieces—an adapter board and a 50-conductor ribbon cable
that connects the Lab board to the rear connector of the adapter board. The
adapter board converts the signals from the Lab board I/O connectors to a
format compatible with the SCXI-1121 rear signal connector pinout at the
front connector of the SCXI-1341 or SCXI-1344. The adapter board also
has an additional male breakout connector that makes the unmodified Lab
board signals accessible to an SCXI-1180 feedthrough panel or an
SCXI-1181 breadboard module. The adapter board gives the Lab boards
full access to the digital control lines and analog signals, but the Lab boards
cannot scan channels in Multiplexed mode. Leave jumper W1 in positionA
on the SCXI-1341 and SCXI-1344. The SCXI-1121 does not use
SCXI-1121 Rear
Signal Connector
Rear Panel
50-Pin Female
Connector to
MIO-16 Board
Mounting Bracket
Mounting Bracket
Connector
Male Breakout
Connector
Step 3
Step 4
Step 4
Step 5