How to Attach Options to the Plasma Monitor
You can attach your optional mounts or stand to the plasma monitor in one of the following two ways:
*As it is made upright. (See Drawing A)
*As it is laid down with the screen face down (See Draw- ing B). Lay the protective sheet, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen face.
•This device cannot be installed on its own. Be sure to use a stand or original mounting unit. (Wall mount unit, Stand, etc)
*See page 2.
•For correct installation and mounting it is strongly recommended to use a trained,authorized NEC dealer.
Failure to follow correct mounting proce- dures could result in damage to the equip- ment or injury to the installer.
Product warranty does not cover damage caused by improper installation.
Drawing A
Drawing B
Ventilation Requirements for enclosure mounting
To allow heat to disperse, leave space between surrounding objects as shown on the diagram be- low when installing.
| Wall |
|
31mm (1.22") | 31mm (1.22") | (2") |
| 1110mm (43.7") | |
| 50mm | |
|
|
748mm (29.5")
50mm (2")
Wall
1
