NEC 50XP10, 42XP10, 60XP10 user manual Repeat Timer, Operation - continued, STATE Settings

Operation - continued

REPEAT TIMER

The Repeat Timer allows the display to alternate between inputs at user-determined intervals.

For example the display can be programmed to show the signal from "VIDEO1" for 10 minutes and then switch to showing the signal from the DVI input for 10 minutes.

To set the Repeat Timer select "REPEAT" in the Timer menu, then press the SET button. To enter the REPEAT TIMER OSD screen. Then make the desired settings.

STATE Settings

There are 4 possible state settings to use. When all four STATES are set to "ON, the repeat timer schedules will operate consecutively (State1, State2, State3, State4, State1, State2, State3...).

When a STATE setting is set to OFF, i.e. STATE1-ON, STATE2-ON, STATE3-OFF, STATE4-ON, the repeat timer schedules use all but STATE3 (State1, State2, State4, State1, State2...).

Repeat Timer activates when the OSD menu is exited.

For SINGLE display configurations

WORK TIME: Set the time duration of the schedule. Time range is from 1 minute to 24 hours.

INPUT MODE: Choose the signal that will be used.

MULTI settings

MODE: Select the input mode to be displayed as “SINGLE”, “S BY S 1, 2R or 2L” or “PICTURE IN PICTURE MODE (BTM LFT~TOP LFT)”.

WORK TIME: Set the time duration of the schedule. Time range is from 1 minute to 24 hours.

INPUT MODE: Choose the signal that will be used. Select “MAIN” or “SUB” for “PICTURE IN PICTURE MODE (BTM LFT~TOP LFT)” and “LEFT” or “RIGHT” for “S BY S1, 2R or 2L”.

Only one signal is selected for “SINGLE”.

English-25