Operation - continued
Picture Size Using Computer Signals
To expand a 4:3 image to fill the entire screen, switch to the widescreen mode.
While viewing videos or digital video discs, perform the following actions:
1.Press the SIZE button on the remote control.
2.To switch the screen sizes, press the SIZE button again within 3 seconds. The available sizes are NORMAL, FULL, and ZOOM.
If an enhanced
NORMAL (4:3 or SXGA 5:4)
Images are displayed normally.
FULL
Horizontally expands anamorphic signals to display the correct linearity.
Normal (4:3) images are horizontally expanded to fill the entire screen.
ZOOM
Vertically and horizontally expands the picture, while maintaining the correct aspect ratio.
TRUE
The image is displayed at the native resolution.
When using a VGA or SVGA signal, PICTURE SIZE in the OPTION 2 OSD menu should be set to OFF to select TRUE mode.
Information:
Supported resolutions: For further information on the display output of the various VESA signal standards supported by the unit, see pages 34 - 39.
When 1360 dot x 768 line wide XGA signals with a vertical frequency of 60 Hz and a horizontal frequency of 47.7 kHz are input:
1.Select an appropriate setting for the RGB SELECT mode.
2.Refer to the Resolutions Supported section of Model Information on pages 34 - 39.
NOTE: Do not display 4:3 content in NORMAL and TRUE mode for extended periods of time to avoid image shadowing, ghosting, or
English