Removing the Stabilisers
To remove the stabilisers follow the next steps:
1.Place the computer body with the bottom side protruding a little away from the edge of a table.
2.Free the locks C and slice the stabilisers as indicated by the arrows A and B, towards the front of the system for stabiliser A and towards the rear for stabiliser B,.
Fig. 1: Removing the stabilisers
Opening the Chassis
To open the chassis, first remove the stabilisers (see Removing the Stabilisers), then follow the next steps:
1.Put the chassis in horizontal position, rear side towards you.
2.Unlock the two cover locks shown in the picture below.
Fig. 2: Unlocking the cover of the chassis
3.Slide the cover towards the front of the chassis a few centimetres, then carefully lift the cover away from the system and set it aside.
NEC PowerMate ML5 Disassembly Manual | Page 5 |
