NEC XT5000 Product, Card I/F, Connector, Manufacturer, List of Recommended Graphics Cards, 10 INPUT 8 S-VIDEO2Terminal (Mini DIN 4 pin)

10 INPUT 8 S-VIDEO 2Terminal (Mini DIN 4 pin)

Connect to the S-video output of the external equipment such as a VCR with an S-video output. This terminal allows switching between S2 and S1 VIDEO input modes. See the "S-Video Mode Select" section for more information.

Push the left side of the panel to open the compartment for the RGB Digital connectors and the optional SDI board.

OUTPUT INPUT9 OUTPUT INPUT 0

RGB

DIGITAL

SDI

11Space to install the optional SDI board.

11 RGB Digital Input/Output Connectors (MDR 20 pin)

These connectors are used for double or triple stacking.

Use the supplied DFP cable to connect the OUTPUT terminal of the first projector to the second projector's INPUT until all the projectors are connected. These connectors can also be used to accept TMDS standard (Pannel Link) digital signal output from a digital ready computer. In this case some graphics cards may cause flickering noise on the screen.

List of Recommended Graphics Cards

Manufacturer	Product	Card I/F	Connector
I-O Data Devices, Inc.	GA-SS21P8/PCI	PCI	DFP 20P
	GA-SM02P2/CB	PCMCIA	DFP 20P
ATI Technologies, Inc.	Expert LCD	AGP	DFP 20P

As of October 31, 1999

NOTE:

* These connectors support a maximum resolution of 1024
768 (XGA).

* A DFP cable must be 5 m (16.4 feet) or less in length.

* Contact your dealer for installing the optional SDI board.

E – 11