4. OPERATION

This section describes how to select a computer or video source, adjust the picture and sound, edit a signal and adjust all other settings and adjustments for proper projector set-up.

General Controls

Before you turn on the projector ensure that the computer or video source is turned on and that the lens cap is removed.

1.Turn On The Projector

Plug the supplied power cable into the AC outlet. The main power switch is on the rear panel of the projector. By turning this switch on, the projector will go into its standby mode and the POWER indicator will glow amber. Only after you press the 'POWER ON' button on the remote control or projector cabinet will the POWER light turn to green and the projector will fully turn on.

2.Select The Computer Or Video Source

Press the INPUT button on the remote control to select the desired source. Or press the MENU button on the remote control and use the Source Select to select your video source: Video, S-Video, RGB, Y/Cr/Cb, RGB Digital or SDI.

3.Adjust The Image

Press the ADJUST PICTURE button or the ADJUST WHITE BAL on the remote control or use the [Main menu]->[Adjustments] to adjust the picture.

4.Turn Off The Projector

First press the POWER OFF button on the remote control or the projector cabinet. Allow the fan to cool the projector for three min- utes. This will extend the life of the lamp. After the cooling fan stops working, the POWER indicator will change to a steady amber glow and the projector will be in the stand-by mode. Then turn off the main power switch on the rear panel. The POWER indicator will go out. If you desire to move the projector then unplug the power cable.

IMPORTANT:

•The projector should be unplugged if it will not be used for an ex- tended period.

•If you want to turn off the image briefly (five minutes or less), press the MUTE PICTURE button instead of turning the projector off and on.

•The projector will display a black, blue image or logo if no input signal is present.

•Do not turn the projector off and then immediately back on. The Projector needs to cool down for three minutes before it is powered on again.

CAUTION: Do not turn off the main power while the cooling fan is working.

Using The Menus

1.Press the MENU button on the remote control to display the Main menu.

2.Use the ▲ or ▼ button on the remote control to select the sub menu.

3.The right-oriented delta symbol indicates further choices are avail- able. Press the  button to highlight the item you want to adjust or set in the selected menu.

4.Press the ▲ or ▼ button on the remote control to select the item.

5.Press the ENTER button on the remote control to display the ad- justment screen or dialog box.

6.Adjust the level or turn the selected item on or off by using  or  on the remote control. The on-screen slide bar will show you the amount of increase or decrease.

NOTE: The change is stored automatically when any one of the following procedures is performed:

*The on-screen dissapears.

*The projector goes into standby.

*One input is switched to another.

7.Repeat steps 2-5 to adjust an additional item, or press the CANCEL button on your remote control to quit.

Using the Magifying Glass Icon

When the image is magnified with the MAGNIFY button on the remote control, pressing CTL and any one of , , ▲, or ▼ will display the magnifying glass icon.

At this time you can select any part of the screen and expand it. To move the magnifying glass icon, use , , ▲, ▼.

Press CTL and any one of , , ▲, or ▼ again and the manifying glass icon will disappear.

E – 29