Setting Up The projector

To set up and use the projector, you must first do:

1.Determine the screen size and the optional lens to be used. NOTE: Refer to page E-14 for lens installation.

2.Set up a screen or select a non-glossy white wall onto which you can project your image.

Moving The Projector

Always carry your projector by the handle. Ensure that the power cord and any other cables connecting to video sources are disconnected before moving the projector. When moving the projector or when it is not in use, cover the lens with the lens cap.

Selecting A Location The further your projector is from the screen or wall, the larger the image. The minimum size the image can be projected is 80" (2 m) measured diagonally. The largest the image can be is 500" (12.7 m).

500"

400"

300"

200"

80" 100"

Pulling Out the Handles

Pull out the handle until it clicks into place.

Retracting the Handles

1) Push the lever to unlock and 2) retract the handle.

WARNING

•Only use your projector on a solid, level surface. If the projector falls to the ground, you can be injured and the projector severely damaged.

•Do not use the projector where temperatures vary greatly. The pro- jector must be used at temperatures between 40 degrees F (5 degree C) and 95 degrees F (35 degree C).

•Do not expose the projector to moisture, dust, or smoke. This will degrade the screen image.

•Ensure that you have adequate ventilation around your projector for proper heat dissipation. Do not cover the vents on the projector cabinet.

E – 16