NETGEAR CG3000Dv2 Gateway Rear Panel

Connecting to the Internet

NETGEAR DOCSIS 3.0 N450 Wi-Fi Data Gateway

Gateway Rear Panel

Ethernet LAN ports

Coaxial cable connector

USB port

Power adapter input

Reset button

Figure 2. Gateway rear panel

The rear panel includes the following connectors, viewed from top to bottom:

•Four Gigabit Ethernet LAN ports. To connect local computers, use these ports.

•USB port. To connect a USB hard drive, flash drive, or printer, use this port.

•Reset. To set the gateway to the original factory settings, press and hold the Reset

button for over 7 seconds. See Factory Default Settings on page 54.

•Coaxial cable connector. Attach a coaxial cable to the cable service provider’s

connection.

•Power. Power adapter input.

Contents

Main Page Contents Chapter 1 Connecting to the Internet Chapter 2 Configuring Your Wireless Network Chapter 3 Filtering Content Chapter 4 Maintaining Your Network Chapter 6 Troubleshooting Appendix A Supplemental Information Appendix B Notification of Compliance Page Gateway Front Panel Connecting to the Internet NETGEAR DOCSIS 3.0 N450 Wi-Fi Data Gateway Gateway Rear Panel Label Wireless Performance and Gateway Location Log In to Your Gateway View Basic Settings Page Set Up Your Wireless Network Configure Wireless Settings Manually Page Use Push 'N' Connect (WPS) Wireless Setup Add a Client Using the WPS Button Page Add a Client Using a PIN Set Up Wi-Fi Multimedia Change the Password Page Page View Denial of Service (DoS) Attack Logs Limit Internet Site Access Allow Unrestricted Access Disable Gateway Features Page Page Page View the Gateway Status View the Connection Status Back Up and Restore Your Settings View the Event Log Run the Diagnostic Utilities Ping Utility Page Traceroute Utility Page Advanced Wireless Settings MAC Filtering Page IP Filtering Port Blocking Port Forwarding Page Port Triggering DMZ Host LAN IP Setup Reserve an IP Address for DHCP Use LAN Switch Configure Universal Plug and Play (UPnP) Set Networking Protocols Enable Network Address Translation Remove USB Devices Page Basic Functions Connect to the Gateways Main Menu Troubleshoot the ISP Connection Troubleshoot a TCP/IP Network Using a Ping Utility Test the LAN Path to Your Gateway Test the Path from Your Computer to a Remote Device Page Page Supplemental Information Factory Default Settings Table 2. Factory default settings Supplemental Information Technical Specifications The following table describes the technical specifications for the gateway. Table 3. Technical specifications Page B B. Notification of Compliance Regulatory Compliance Information Europe EU Declaration of Conformity FCC Requirements for Operation in the United States FCC Information to User FCC Guidelines for Human Exposure FCC Caution Canadian Department of Communications Radio Interference Regulations Industry Canada Caution: Notification of Compliance Avertissement: IMPORTANT NOTE: Radiation Exposure Statement: NOTE IMPORTANTE: Dclaration d'exposition aux radiations: Interference Reduction Table