NETGEAR DOCSIS 3.0 N450 Wi-Fi Data Gateway

Port Blocking

You can use port blocking to block outbound traffic on specific ports. Outbound traffic rules control access to outside resources from local users. The default rule is to allow all access from the LAN side to the outside. You can use port blocking to add predefined or custom rules to specify exceptions to the default rule.

Note: The default rule allows any outbound traffic not blocked by rules that you create.

To configure port blocking:

1.In the main menu, under Advanced, select Port Blocking.

2.From the Service list, select the service you want to block.

3.To add a custom service that is not in the list of services, specify these settings in the Add Custom Service table:

Name. A name for the service.

Start Port. The start port for the service.

End Port. The end port for the service.

Protocol. The protocol for the ports:

-TCP. TCP only.

-UDP. UDP only.

-Both. Both TCP and UDP.

Local IP Address. Complete the local IP address for the computer that is using the service.

4.Perform one of the following actions:

Click Add to save your settings. The Active Filters table now displays the list of ports that are currently blocked.

To delete a service, select the radio button in the Active Filters table for the service that you want to delete, and click Delete.

To reset the selection in the Services drop-down list and to clear all the fields in the Add Custom Service table, click Reset.

Port Forwarding

A firewall has default rules for inbound traffic (WAN to LAN) and for outbound traffic. Port forwarding affects the inbound rules. These rules restrict access from outsiders. By default,

Advanced Settings

39

Page 39
Image 39
NETGEAR CG3000Dv2 user manual Port Blocking, Port Forwarding,  To configure port blocking