Configuring the RS485 card for Comet

2. Installation

The settings proposed below comply with the recommended configuration (see section "Single-unit type installation"). They must be made before installing and commissioning the PowerServices TelPac external unit.

The slave number is set to 1 by default. Parameters may be set using UPS Tuner or Soft-Tunor.

XM1

XM2

JOJO 6761294

OFF

Configuration

for Comet

XM5

XM3

XM4

34003602EN/AB - Page 21

Page 21

Image 21

MGE UPS Systems 100 installation manual Configuring the RS485 card for Comet, For Comet

Contents

Installation manual PowerServicesTM TelPac 2 34003602EN/AB Introduction Special precautionsEnvironment Recycling of packaging EMC compatibility ForewordFederal Communication Commission FCC statement Radio and Telecommunications compatibility List of countries supported by the modem Modem compatibility and supported countries Pictogram symbols Contents Maintenance Presentation Unpacking and checking the contents Overview Functions Country Teleservice Centre Power supply Technical data sheetRS485 Port Modem Indicator lights Status Green UPS indicator Card version External versionStatus Red CD indicator Card version External version Installation ProcedurePreliminary check Various installation types Fitting the warning label Recommendations Galaxy PW MGE Attention Onduleur sous Teleservice Single-unit type installation Setting up the RS485 linkGeneral UPS with Jbus Impedance matching and bias settings = Shielding Configuring the shielding terminal For Comet Configuring the RS485 card for Comet Configuring the Rauz card for Galaxy Connection Installing the PowerServices TelPac card Connections Comet S31 7.5/10KVA Comet S31 15/20KVA Open the doors giving access to Galaxy view with doors open and protective panels in place PowerServices TelPac card 2 inputs Connecting contact type inputs 5V B PowerServices TelPac external unit 2 inputs + 4 extensions Maintenance Cable diagramsComet link cable ref