MGE UPS Systems 100 installation manual Open the doors giving access to

2. Installation

2.9 Installing the PowerServices TelPac external unit for Galaxy UPSs

Installation must be carried out by our technicians.

Installation of the PowerServices TelPac external unit requires UPS shut down, load tranfer to bypass and removal of three protective panels.

Refer to the UPS’s user manual to carry out shut-down procedures in full compliance with safety procedures and instructions. Non-compliance with these may lead to safety hazards for the people concerned.

Galaxy view with doors open and protective panels removed

17

18

		Installation, connections
		1 - Open the doors giving access to the
		switch handles,
		2 - Carry out the UPS shut-down procedure
		and remove the three protective panels,
		3 - Check:
		◗that the UPS is equipped with at least one
	21	GTCZ communication card 17 and one
XR11		RAUZ card 18 .
		◗that a protected and UPS-secured outlet
		19 is available.
		4 - Configure the RAUZ and GTCZ card as
		indicated in section 2.6.
1 black	19	5 - Connect the power supply adapter to the
2 brown		UPS-secured outlet 19 . Bring the power
4 red	20	supply cord 20 out through the grommet in
		panel A.
XR11		6 - Connect, install then fix link cable 21 .
RAUZ card		Bring the other end of the cable out through
		the grommet in panel A.
		7 - Replace the protective panels.

Page 26 - 34003602EN/AB