Brother HL-960 manual Error Messages, Buffer Error, Memory Full, Line Error, Print Check

		CHAPTER 7 TROUBLESHOOTING
Error Messages
Error Message	Meaning	Action
31 PRINT OVERRUN	Print overrun	Press the CONTINUE switch
		to start printing the next page.
		Data which overran the print
		area on the page cannot be
		printed. Check your page
		protection setting with the
		MODE switch. Setting page
		protection to the correct size
		could solve this problem. If
		printing at 600 dpi, you may
		need to add optional SIMM
		memory. See page 5-6.
32 BUFFER ERROR	Input buffer overflow	Press the CONTINUE switch
		to resume printing. Data lost
		in overflow cannot be printed.
		See page 4-41.
34 MEMORY FULL	Work memory overflow	Press the CONTINUE switch
		to resume printing. If the
		same error should occur after
		you press the CONTINUE
		switch, turn off the printer.
		Wait a few seconds, then turn
		it on again. Reduce the input
		buffer size. See page 4-41.
		Turn off “KEEP PCL.” Add
		SIMM memory with power
		off. Download font and the
		fonts saved in the HDD card
		might cause the error, for it
		occupies the same work area
		as the RAM. Memory
		expansion is recommended in
		that case. See page 5-6.
40 LINE ERROR	Error in the communications	When the serial interface is
	circuit	used, check the
		communications parameters
		such as baud rate, code type,
		parity, and handshake
		protocols. When the parallel
		interface is used, check the
		interface cable connection.
41 PRINT CHECK	Error in communication with	Turn off the printer. Wait a
	the engine controller	few seconds, then turn it on
		again.

7–3