Brother HL-960 manual FEEDER=MP Tray, FEEDER=TRAY1, FEEDER=TRAY2

USER’S GUIDE

FEEDER=AUTO *

3.Press the ▲ or ▼ switch until the desired feeder appears on the display.

Display Message	Paper Feed Method/Paper Source
FEEDER=AUTO	Auto paper feed
FEEDER=MP TRAY	Cassette feed from multi-purpose
	tray (MP tray)
FEEDER=TRAY1	Upper paper cassette (Tray 1)
FEEDER=TRAY2	Lower paper cassette (Tray 2)

✒Notes

When you select a feeder, note the following:

∙The “FEEDER=TRAY2” message appears only when the optional lower tray unit has been installed.

∙The FEEDER=AUTO setting allows you to optimize your printing environment. This setting allows a print job to continue uninterrupted when a paper out condition occurs. The default setting is AUTO. This setting allows a common printing situation: Loading the same size and type of paper in all paper trays. This allows your print job to continue without error if one of the paper trays becomes empty. The printer will automatically select another tray if one tray becomes empty.

∙When you select the FEEDER=AUTO, the printer automatically searches for the paper size you set with the MODE switch in the PAGE FORMAT mode and loads the paper from the paper source that contains the selected size of paper. If all of the upper and lower paper cassettes and the multi-purpose tray contain the different size of paper and one paper cassette runs out of paper, the printer stops printing without automatically changing to the other paper source to feed paper. It prevents different size of paper from being printed by mistake.

∙If you have the same size of paper loaded but of different type (i.e.: FORM “A” in Tray 1, FORM “B” in Multi-purpose Tray) it is recommended to change the feeder setting from AUTO to Tray 1. This setting will allow the printer to pause when a paper empty condition occurs, allowing you to load the correct type of paper, then press SEL to finish to print job.

4.Press the SET switch to make the displayed selection effective.

4–66