Brother HL-960 manual High SPEED=ON, Bi-Dir=On

USER’S GUIDE

Even if you choose the automatic interface selection, you need to set the communications parameters for the serial interface, high speed/bi- directional communications for the parallel interface. See the tables below.

For further information about automatic interface selection, see “AUTOMATIC INTERFACE SELECTION” in Chapter 3.

■Parallel Interface

When you intend to use the bi-directional parallel interface, select the interface on the display as follows:

I/F=PARALLEL

When you use the parallel interface, you need to set the communications mode in the following sub-setting menu.

Display Message	High Speed and Bi-directional Parallel
	Communications
HIGH SPEED=ON	Turns on or off the high speed parallel
	communications.
BI-DIR=ON	Turns on or off the bi-directional parallel
	communications.

The above high-speed and bi-directional settings are used for the bi-directional parallel interface of this printer. The bi-directional parallel interface is compatible with the standard bi-directional parallel interface. Although it uses the same cable, hardware, and software as the bi-directional parallel interface, to use its enhanced capabilities—such as bi-directional communication between the computer and printer and faster transmission of data—you need printer driver or software that supports these features. Check with your software vendor to see if your software supports bi-directional parallel features.

■Serial Interface

When you intend to use the serial interface, be sure to select the same communications parameters on both the printer and computer. You must set them for the automatic interface selection, too.

4–16