NETGEAR DG834G manual Any-the remote VPN endpoint may be at any IP address

Reference Manual for the ADSL Modem Wireless Router DG834G

General. The DG834G v3 VPN tunnel network connection fields are defined as follows:

•Policy Name—enter a unique name to identify this policy. This name is not supplied to the remote VPN endpoint. It is used only to help you manage the policies.

•Remote VPN Endpoint—select the desired option (IP address or Fully Qualified Domain Name) and enter the address of the remote VPN endpoint to which you wish to connect.

Note: The remote VPN endpoint must have this VPN Gateway's address entered as its "Remote VPN Endpoint".

Local LAN. This identifies which PCs on your LAN are covered by this policy. For each selection, data must be provided as follows:

•Single address—enter an IP address in the "Single/Start IP address" field. Typically, this setting is used when you wish to make a single Server on your LAN available to remote users.

•Range address—enter the starting IP address in the "Single/Start IP address" field, and the finish IP address in the "Finish IP address" field. This must be an address range used on your LAN.

•Subnet address—enter an IP address in the "Single/Start IP address" field, and the desired network mask in the "Subnet Mask" field.

•Any—the remote VPN endpoint may be at any IP address.

The remote VPN endpoint must have these IP addresses entered as its "Remote" addresses.

Remote LAN. This identifies which PCs on the remote LAN are covered by this policy. For each selection, data must be provided as follows:

•Single PC - no Subnet—select this option if there is no LAN (only a single PC) at the remote endpoint. If this option is selected, no additional data is required.

•Single address—enter an IP address in the "Single/Start IP address" field. This must be an address on the remote LAN. Typically, this setting is used when you wish to access a server on the remote LAN.

•Range address—enter the starting IP address in the "Single/Start IP address" field, and the finish IP address in the "Finish IP address" field. This must be an address range used on the remote LAN.

•Subnet address—enter an IP address in the "Single/Start IP address" field, and the desired network mask in the "Subnet Mask" field.

Virtual Private Networking 8-49

v1.2, October 2006