Reference Manual for the ProSafe VPN Firewall FVS318v3
8-4 Advanced Configuration
January 2005

Using the Firewall as a DHCP server

By default, the firewall functions as a DHCP (Dynamic Host Configuration Protocol) server,
allowing it to assign IP, DNS server, and default gateway addresses to all computers connected to
the firewall's LAN. The assigned default gateway address is the LAN address of the firewall. IP
addresses will be assigned to the attached PCs from a pool of addresses specified in this menu.
Each pool address is tested before it is assigned to avoid duplicate addresses on the LAN.
For most applications, the default DHCP and TCP/IP settings of the firewall are satisfactory. See
“IP Configuration by DHCP” on page B-10” for an explanation of DHCP and information about
how to assign IP addresses for your network.
If another device on your network will be the DHCP server, or if you will manually configure the
network settings of all of your computers, clear the Use router as DHCP server check box.
Otherwise, leave it checked.
To specify the pool of IP addresses to be assigned, set the Starting IP Address and Ending IP
Address. These addresses should be part of the same IP addres s subnet as the firewall’s LAN IP
address. Using the default addressing scheme, you should define a range between 192.168.0.2 and
192.168.0.253, although you may wish to save part of the range for devices with fixed addresses.
The firewall will deliver the following parameters to any LAN device that requests DHCP:
An IP address from the range you have defined
Subnet m ask
Gateway IP address (the firewall’s LAN IP address)
Primary DNS server (if you entered a primary DNS address in the Basic Settings menu;
otherwise, the firewall’s LAN IP address)
Secondary DNS server (if you entered a secondary DNS address in the Basic Settings menu
Note: If you change the LAN IP address of the firewall while connected through the
browser, you will be disconnected. You must then open a new connection to the new IP
address and log in again.