Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302

Use WPA or WPA-PSK.Wi-Fi Protected Access (WPA) data encryption provides data security. The very strong authentication along with dynamic per frame rekeying of WPA make it virtually impossible to compromise. Because this is a new standard, wireless device driver and software availability may be limited.

Use AutoCell Enhanced RF Security ‘Stealth Mode.’ In addition to standard encryption and security mechanisms such as WEP and WPA, the WAG302 AutoCell feature provides self-organizing micro cells for an additional level of privacy for enterprises. In this mode, AutoCell shrinks the size of coverage to the minimum to reach clients but also shrinks the size of the beacons that access points use to announce their presence. This mode makes an enterprise wireless LAN nearly invisible to users outside an office building. AutoCell clients such as the NETGEAR WAG511 are highly-recommended for Enhanced RF Security.

Installing the WAG302 Access Point

Before installing the WAG302 ProSafe Dual Band Wireless Access Point, you should make sure that your Ethernet network is up and working. You will be connecting the access point to the Ethernet network so that computers with 802.11b or 802.11a/g wireless adapters will be able to communicate with computers on the Ethernet network. In order for this to work correctly, verify that you have met all of the system requirements, shown on page 2-5.

1SET UP THE WAG302 ACCESS POINT

Tip: Before mounting the WAG302 in a high location, first set up and test the WAG302 to verify wireless network connectivity.

a.Prepare a computer with an Ethernet adapter. If this computer is already part of your network, record its TCP/IP configuration settings.

b.Configure the computer with a static IP address of 192.168.0.36 and 255.255.255.0 for the Subnet Mask.

c.Connect an Ethernet cable from the WAG302 to the computer.

d.Turn on your computer, connect the power adapter to the WAG302 and verify the following:

The PWR power light goes on.

The LAN light of the wireless access point is lit when connected to a powered on computer.

The WLAN LEDs should be blinking.

Basic Installation and Configuration

3-5

202-10078-01

Page 27
Image 27
NETGEAR manual Installing the WAG302 Access Point, SET UP the WAG302 Access Point