Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302

All APs must be on the same LAN. That is, all the APs LAN IP address must be in the same network.

If using DHCP, all WAG302 Access Points should be set to “Obtain an IP address automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings menu.

All WAG302 Access Points use the same SSID, Channel, authentication mode, if any, and encryption in use.

All Point-to-Point APs must have AP2’s MAC address in its Remote AP MAC address field.

3.Verify connectivity across the LANs.

A computer on any LAN segment should be able to connect to the Internet or share files and printers with any other PCs or servers connected to any of the three LAN segments.

Wireless stations will not be able to connect to the WAG302 Access Points in the illustration above. If you require wireless stations to access any lan segment, you can additional WAG302 Access Points configured in Wireless Access Point mode to any LAN segment.

Note: You can extend this multi-point bridging by adding additional WAG302s configured in Point-to-Point mode for each additional LAN segment. Furthermore, you can extend the range of the wireless network with NETGEAR wireless antenna accessories.

5-12

Advanced Configuration

202-10078-01

Page 80
Image 80
NETGEAR WAG302 manual Advanced Configuration