Linear AE-100 Access to Programming, Programming from the Keypad Standard Method, Press, m n o

Access to Programming

To make it easy for installers familiar with Linear’s and other manufacturer’s access control systems, two methods of programming are available. Programming Position Numbers (or Function Codes) that match other equipment help the installer to make quick programming changes with keystrokes they’ve used before.

Automatic Programming Method Selection

The Programming Position Numbers (or Function Codes) change depending on the programming method used. Refer to the table on Page 13 for the numbers used for each programming method.

The keys used to enter programming from the unit’s keypad select which programming method is used for the current programming session.

Entering programming by pressing&keys together will select the Standard Programming Method (Linear Access style). Details of each programming step when using the Standard Programming Method are shown on Pages 7-13.

Entering programming by pressing & keys together will select the Alternate Programming Method (other manufacturer’s style). Details of each programming step when using the Alternate Programming Method are shown on Pages 15-21.

PRESS	AND	TOGETHER
	FOR
STANDARD PROGRAMMING METHOD

PRESS	AND	TOGETHER
	FOR
ALTERNATE PROGRAMMING METHOD

Programming from the Keypad (Standard Method)

The system can be programmed using the keypad on the faceplate of the AE-100. The display will show the programming information.

Accessing Programming from the Keypad

1.Press & keys at the same time, then release.

2.The display will show [PASSWORD:].

3.Enter the Master Password (factory setting is 123456).

4.Press:

5.If the password is correct, the display will show [ENTER FUNCTION:].

6.Programming commands can now be entered on the keypad. Refer to the following sections of this manual for programming step details. Also refer to the fi gure for alphanumeric entry using the keypad.

Keypad Audio Prompts

When programming using the keypad, each programming step consists of entering programming data. With the Standard Programming Method, the system will sound beeps to indicate correct or incorrect entries.

•After a correct entry, two short beeps will sound.

•After an incorrect entry, one long beep will sound.

•After the complete programming step has been entered correctly, three short beeps will sound.

Re-entering a Command After a Mistake

If an incorrect entry, or an incorrect key is pressed during programming, to

clear the keypad press and start the programming step over again.

Exiting Programming Mode

1. Press:

✦NOTE: The AE-100 will automatically exit Programming Mode after two minutes of programming inactivity.

KEYPAD ALPHANUMERIC ENTRY

(FOR PROGRAMMING STEPS REQUIRING TEXT)

a b c d e f	g h i
m n o
j k l	p q r
v w x
s t u	y z ,

backspacefinish

or erase entry entire line

space, minus sign, dot

•1ST PRESS IS 1ST LETTER

•2ND PRESS IS 2ND LETTER

•3RD PRESS IS 3RD LETTER

•4TH PRESS IS THE KEY NUMBER

•5TH PRESS IS 1ST LETTER AGAIN

•WAIT 3 SECONDS FOR THE NEXT CHARACTER (A BEEP WILL SOUND AFTER THE 3 SECOND DELAY TIME) OR PRESS ANOTHER KEY

•THE FIRST LETTER OF EACH WORD WILL BE UPPER CASE,

TO MAKE AN ENTIRE WORD UPPER CASE TEXT, ENTER # FIRST

•FINISH ENTRY BY ENTERING #

•PRESS STAR KEY TO BACKSPACE, PRESS STAR AGAIN TO ERASE LINE

4