STANDARD PROGRAMMING METHOD
System Utility Commands
Several utility commands are available for the system. Utility commands can be used to copy data to other units in a
For each of the following steps, enter the Master Password and enter Programming Mode (if the unit is not already in that mode). Exit Programming Mode when all programming is complete.
Copy Access Data Only from Master to Sub-units
To synchronize programming in
✦NOTE: The installer must setup the system as a
✦NOTE: This utility command can only be performed from the “master” unit.
CAUTION: This utility command will overwrite ALL the access data in the selected
1.Press
2.Enter the unit number(s) of all of the
•To copy to unit two only enter
•To copy to unit three only enter
•To copy to units two & three enter
•To copy to units two, three, and four enter
3.To execute the command, enter or enter to exit (any other entry will abort the command).
30#SUB-UNITS#5#
NOTE:
TO ALLOW FOR
Copy All Data from Master to Sub-units
To synchronize programming in
✦NOTE: The installer must setup the system as a
✦NOTE: This utility command can only be performed from the “master” unit.
CAUTION: This utility command will overwrite ALL the data in the selected
1.Press
2.Enter the unit number(s) of all of the
•To copy to unit two only enter
•To copy to unit three only enter
•To copy to units two & three enter
•To copy to units two, three, and four enter
3.To execute the command, enter or enter to exit (any other entry will abort the command).
COPY ALL DATA FROM MASTER TO | PPN 34 |
34#SUB-UNITS#5#
SUB-UNITS = EACH SUB-UNIT NUMBER (2-4) TO COPY
ALL DATA TO IN A MULTI-UNIT INSTALLATION
NOTE:
TO ALLOW FOR
12