126
Appendix A CONFIG Commands
.
Specifies restrictions on the types of traffic the 3220-H accepts over the DSL vir-
tual circuit. The admin-disable argument means that router traffic is
accepted but that administrative commands are ignored. The admin-only
argument means that router traffic is ignored by that administrative commands
are accepted. The none argument means that all traffic is accepted. RIP and
ICMP traffic is still accepted.
Specifies whether you want the 3220-H to use network address translation (NAT)
when communicating with remote routers. Address mapping lets you conceal
details of your network from remote routers. It also permits all LAN devices to
share a single IP address.
By default, address mapping is turned “On”.
Specifies whether you want the 3220-H to respond when it receives an address
resolution protocol for devices behind it.
By default, proxy ARP is turned “Off”.
Ethernet Settings
Enables or disables communications through the designated Ethernet port in the
Gateway. You must enable TCP/IP functions for and Ethernet port before you can
configure it network settings
.
Assigns an IP address to the Cayman Gateway on the local area network. The IP
address you assign to the local Ethernet interface must be unique on your net-
work. By default, the Cayman Gateway uses 192.168.1.254 as its LAN IP address.
DSL set ip dsl
vccn
restriction { admin-disabled | admin-only|
none }
DSL set ip dsl vccn addr-mapping { on | off }
DSL set ip dsl vccn proxy-arp { on | off }
ENET set ip ethernet [ A | B ] option { on | off }
Many of these setting commands are designated as BOTH.
Note however:
For the 2E-H (ENET platform) you have the option of selecting the A
or B ethernet port within the line command.
For the 3220-H (DSL platform) you are specifying the A port (your
local LAN) only.
BOTH set ip ethernet [ A | B ] address
ip_address