Appendix A | CONFIG Commands |
•The remote network is more than one router away but the static route should not be replaced by a dynamic route, even if the dynamic route is more effi- cient.
BOTH
delete ip
Deletes a static route. Deleting a static route removes all information associated with that route.
WAN Settings
Many of these setting commands are designated as BOTH. Note however:
For the
This argument does not apply to the
Also note that the
BOTH
set ip wan [vccn] option { on off }
Enables or disables communications through the WAN Ethernet port [or specified VCC Interface] in the Cayman Gateway. You must enable TCP/IP [or BNCP] func- tions for the WAN port before you can configure its network settings.
BOTH | set ip wan [vccn] address | ip_address |
| Assigns an IP address to the Cayman Gateway on the WAN [or specified VCC | |
| interface]. The IP address you assign must be unique on your network. | |
|
|
|
BOTH | set ip wan [vccn] broadcast | broadcast_address |
Specifies the broadcast address for the TCP/IP network connected to the WAN Ethernet port [or specified VCC interface]. IP hosts use the broadcast address to send messages to every host on your network simultaneously.
The broadcast address for most networks is the network number followed by 255. For example, the broadcast address for the 192.168.1.0 network would be 192.168.1.255. .
BOTH
set ip wan [vccn] netmask | netmask |
Specifies the subnet mask for the TCP/IP network connected to the WAN Ethernet port [or specified VCC interface]. The subnet mask specifies which bits of the 32- bit binary IP address represent network information. The default subnet mask for most networks is 255.255.255.0 (Class C subnet mask).
133