Appendix A | CONFIG Commands |
SNMP Settings
The Simple Network Management Protocol (SNMP) lets a network administrator monitor problems on a network by retrieving settings on remote network devices. The network administrator typically runs an SNMP management station program on a local host to obtain information from an SNMP agent such as the Cayman Gateway.
BOTH | set snmp community | name |
| Adds the specified name to the list of communities associated with the Cayman | |
| Gateway. By default, the Cayman Gateway is associated with the public commu- | |
| nity. You can associate as many as 16 communities with the Cayman Gateway. |
BOTH set snmp traps authentication-traps { on off }
Enables or disables SNMP trapping. If SNMP trapping is enabled, your Cayman Gateway sends authentication traps to all SNMP trap destinations. You must enable trap authentication before you set up your trap destinations.
BOTH | set snmp traps |
| [ community |
| ] |
| Identifies the destination for SNMP trap messages. The | ||||
| the IP address of the host acting as an SNMP console. The optional |
| |||
| community |
| |||
| community, which is included in the trap message the device sends to the man- | ||||
| agement console. This name, which is not used for authentication, does not have | ||||
| to match a predefined community name. |
|
|
BOTH | set snmp sysgroup contact | contact_info |
| Identifies the system contact, such as the name, phone number, beeper number, | |
| or email address of the person responsible for the Cayman Gateway. You can | |
| enter up to 256 characters for the contact_info argument. You must put the | |
| contact_info argument in |
BOTH | set snmp sysgroup location | location_info |
Identifies the location, such as the building, floor, or room number, of the Cay- man Gateway. You can enter up to 256 characters for the location_info argu- ment. You must put the location_info argument in
System Settings
You can configure system settings to assign a name to your Cayman Gateway and to specify what types of messages you want the diagnostic log to record.
BOTH
set system name | name |
Specifies the name of your Cayman Gateway. Each Cayman Gateway is assigned a name as part of its factory initialization. The default name for a Cayman Gate- way consists of the word
145