Netopia 6.3 Both set ip ethernet a B proxy-arp on off, Set ip ethernet B addr-mapping off on

Appendix A CONFIG Commands

.

BOTH set ip ethernet [ A B ] proxy-arp { on off }

Specifies whether you want the Cayman Gateway to respond when it receives an address resolution protocol for devices behind it. By default, proxy ARP is turned off.

BOTH set ip ethernet [ A B ] rip-send

{ off v1 v2 v1-compat v2-MD5 }

Specifies whether the Cayman Gateway should use Routing Information Protocol (RIP) broadcasts to advertise its routing tables to other routers on your network. RIP Version 2 (RIP-2) is an extension of the original Routing Information Protocol (RIP-1) that expands the amount of useful information in the RIP packets. While RIP-1 and RIP-2 share the same basic algorithms, RIP-2 supports several new fea- tures, including inclusion of subnet masks in RIP packets and implementation of multicasting instead of broadcasting (which reduces the load on hosts which do not support routing protocols. RIP-2 with MD5 authentication is an extension of RIP-2 that increases security by requiring an authentication key when routes are advertised.

Depending on your network needs, you can configure your Cayman Gateway to support RIP-1, RIP-2, or both.

BOTH

set ip ethernet [ A B ] rip-receive

{ off v1 v2 v1-compat v2-MD5 }

Specifies whether the Cayman Gateway should use Routing Information Protocol (RIP) broadcasts to update its routing tables with information received from other routers on your network.

.

ENET

set ip ethernet B addr-mapping { off on }

Specifies whether Network Address Translation (NAT) is enabled for the WAN (Ethernet B) port on the Cayman Gateway.

Default IP Gateway Settings

BOTH set ip gateway option { on off }

Specifies whether the Cayman Gateway should send packets to a default Gateway if it does not know how to reach the destination host.

ENET set ip gateway interface { ip-address ppp }

Specifies how the Cayman 2E-H should route information to the default Gateway. If you select ip-address, you must enter the IP address of a host on a local or remote network. If you specify ppp, the Cayman unit uses the default gateway being used by the remote PPP peer.

128