RFT2 Rack Kit Installation Guide
07/01/06 Rev 1.0 Page 6 of 13
Cable Management Installation1. With the RFT installed, go to the back of the rack to
install the cable management system.
2. Attach Part A to part extension of outer member on
the left slide.
3. Connect Part B to the inside right hand side slide
member by sliding it into place. A “click” will be heard
once it is secured. The Cable Management System
is designed to have the cross-support beam on the
bottom…not the top.
4. Connect Part C to the outside right hand side slide
member. Note that the extruded portion on the top of
Part C needs to line up with the mating portion on the
outer slide member. Similar to Step 2 above. A “click”
will be heard once it is secured.
5. Insert Part D into Part A on the left hand side. The
large tab on Part A will keep Part D in place.
Part
A
Note the guide tha t will fit into
the mating portion on the slide
Part
B
Part
C
Part
A
Part
D