Installing the Bagger
Discharge
1. Raise the Discharge Guard on your MowerGuard (Figure 10) and note the metal Support
Rod at the rear of the Mower.
2.Grasp the Bagger by the Top Handle
(Figure 11) and center it at the back of the Mower.
3.Align the Metal Latch Hooks (Figure 11) over the Support Rod (Figure 12) and lower the Bagger in place until the Wire Frame at the bottom of the Bagger rests on the Mower.
Support Rod
4. Lower the Discharge Guard.
Removing and Emptying the Bagger
1.Raise the Discharge Guard.
2.Using the Top Handle of the Bagger, lift the Bagger off the Support Rod and away from the Mower.
3.Lower the Dischage Guard.
4.To empty the Bagger, tilt the Top Handle forward. Use the Cloth Handle (Figure 13) at the rear of the Bagger to move the contents toward the front as you empty the Bagger.
Figure 10
Latch Hooks
Top Handle
Figure 11
Latch Hook
Latch Hooks
Support Rod
Figure 12
Cloth Handle
Figure 13
NEUTON CE 6.2 | 15 |