Neuton CE 6.2 manual Balancing the Blade

Models: CE 6.2

1 66
Download 66 pages 43.65 Kb
Page 43
Image 43
Balancing the Blade

Balancing the Blade

An out-of-balance Blade causes your machine to vibrate excessively. Excessive vibration may cause damage to the Mower, especially the Motor.

Because you are removing metal from the Blade, make sure to remove an equal amount from each end to keep the Blade balanced. The best way to balance a Blade is with a Blade Balancer (available at most local Hardware stores); or with a large Screwdriver, Nail, or Bolt.

Tools and Supplies Needed:

Gloves

Blade Balancer, or a large Screwdriver, Nail, or Bolt

1.After sharpening the Blade, hang it on the Balancer and check the level (Figure 31). If one side of the Blade tips lower than the other side, sharpen the lower end a little at time until the Blade is level (balanced).

NOTE: When sharpening a used Blade, be especially careful to keep it balanced. If in doubt, replace the Blade with a new one. Of course, you can always have a Mower Service sharpen and balance your Blade.

Balanced

Screwdriver

Figure 31

NEUTON CE 6.2 Battery-Powered Mower - Safety & Operating Instructions

39

Page 43
Image 43
Neuton CE 6.2 manual Balancing the Blade