Neuton CE 6.2 manual ⇒Status Indicator Light, ⇒Cutting Height Lever, ⇒Power/Mode Switch

Models: CE 6.2

1 66
Download 66 pages 43.65 Kb
Page 23
Image 23
⇒Status Indicator Light

Status Indicator Light

The green Status Indicator Light on the Lower Crossbar (Figure 16) lights up when you install a charged Battery and insert the Safety Key.

NOTE: A green Status Indicator Light does not guarantee that the Battery is fully charged, only that it has some charge, the Safety Key has been inserted, the electrical system is ready, and that the Mower can be started.

Status Indicator Light

Figure 16

IF THE GREEN STATUS INDICATOR LIGHT GOES OUT, DO NOT OPERATE THE MOWER AGAIN UNTIL THE BATTERY IS FULLY CHARGED. IF YOU DO OPERATE THE MOWER WITH THE GREEN STATUS INDICATOR LIGHT OUT, THIS WILL RESULT IN DECREASED CHARGING CAPACITY.

NOTE: Although you may notice that a short period of rest may restore the Status Indicator Light, you still must fully charge the Battery before continuing to mow. For best results, be sure to always fully charge the Battery for eight (8) to twenty-four (24) hours after every use.

Cutting Height Lever

The Cutting Height Lever (Figure 17), located under the Access Cover, allows you to easily adjust how high or low you cut the grass. Notice that there are four (4) different Height Positions.

To easily move the Cutting Height Lever, hold TIP the Handlebar with your right hand to keep the

Mower steady and adjust the Lever with your left hand.

To easily adjust this Lever, push the Lever out of its present notched position and move the Lever up or down to the desired level. When you reach the desired level, simply release the Lever into the notch.

Power/Mode Switch

The Power/Mode Switch (Figure 18) controls the Mower, Power, and optional Trimmer. This Switch has three (3) settings.

Mower (rear position), used for normal mowing; and

Power OFF (center position), used to conserve Battery power (green Status Indicator Light goes out); and

Auxiliary (forward position), used when operating the Optional Trimmer.

Access Cover

Positions

1=1.2" (3.0cm)

2=1.5" (3.8cm) Cutting Height Lever 3=2.0" (5.1cm)

4=2.8" (7.0cm)

Figure 17

Power/Mode Switch

Figure 18

NEUTON CE 6.2 Battery-Powered Mower - Safety & Operating Instructions

19

Page 23
Image 23
Neuton CE 6.2 manual ⇒Status Indicator Light, ⇒Cutting Height Lever, ⇒Power/Mode Switch